Science NCERT class 8 Chapter 6 Combustion and Flame
Exercise Questions
1. List conditions under which combustion can take place.
Soln:
The burning of a substance in the presence of oxygen is defined as combustion.
The conditions under which combustion can take place are
- The presence of air or oxygen.
- The presence of fuel plays a significant role.
- Ignition temperature is maintained (It is defined as the substance that catches fire at its lowest temperature.)
2. Fill in the blanks.
(a) Burning of wood and coal causes __________of air.
(b) A liquid fuel, used in homes is__________ .
(c) Fuel must be heated to its ____________ before it starts burning.
(d) The fire produced by oil cannot be controlled by___________ .
Soln:
(a) Burning of wood and coal causes Pollution of air.
(b) A liquid fuel, used in homes is Kerosene.
(c) Fuel must be heated to its Ignition Temperature before it starts burning.
(d) The fire produced by oil cannot be controlled by Water.
3. Explain how the use of CNG in automobiles has reduced pollution in our cities.
Soln:
CNG played an important role in reducing pollution among automobiles for the following reasons
- CNG is comparatively a cleaner fuel.
- The CNG can be an alternative for diesel, petrol and propane/LPG.
- It usually contains a few undesirable gases than the other fuels mentioned above.
- The combustion of fuels like petroleum causes many unburnt carbon particles along with carbon monoxide which leads to respiratory diseases.
4. Compare LPG and wood as fuels
Soln:
Wood
- It is considered as a traditional fuel used for both domestic and industrial purposes.
- Wood produces a lot of smoke which pollutes the atmosphere and cause respiratory diseases.
- The usage of wood to a large extent causes deforestation.
- The calorific value of wood ranges between 17000 to 22000 kJ/kg
- However, wood may be used as a furnace, stove or fireplace in indoors while it is used for a campfire, furnace at outdoors.
LPG
- The usage LPG (Liquefied petroleum gas) has replaced wood.
- It doesn’t release smoke and other pollutants
- It is a cleaner fuel
- The fuel efficiency of LPG is more than that of wood.
- The calorific value of LPG is 55000 kJ/kg
- Hence LPG is mostly preferred choice
5. Give reasons.
(a) Water is not used to control fires involving electrical equipment.
(b) LPG is a better domestic fuel than wood.
(c) Paper by itself catches fire easily whereas a piece of paper wrapped around an aluminium pipe does not.
Soln:
a)
- Water is a good conductor of electricity.
- If added to an electrical fire, the water would just spread the electricity further.
- The person dousing the fire might get an electric shock
b)
- LPG being a cleaner fuel than wood doesn’t release smoke and other pollutants.
- Wood, on the other hand, releases a lot of smoke and fumes polluting the atmosphere causing pollution and leading to respiratory diseases.
- Hence LPG is a better domestic fuel than wood.
c)
- The paper by itself catches fire easily because of its low ignition temperature
- The piece of paper wrapped around an aluminium pipe doesn’t catch fire because aluminium is a good conductor of electricity.
- While the paper wrapped around an aluminium pipe results in an increase in ignition temperature. So there is a transfer of heat from paper to the aluminium pipe. Hence it doesn’t catch fire.
6. Make a labelled diagram of a candle flame.
Soln:
7. Name the unit in which the calorific value of a fuel is expressed.
Soln:
Calorific value is defined as the energy contained in the fuel. It is expressed in the form kJ/kg
kJ=kilo joules and kg=kilogram
8. Explain how CO2 is able to control fires.
Soln:
CO2 is a non-combustible gas and extinguishes fire in two ways:
(i) It is heavier than oxygen and it covers the fire like a blanket and cuts off the contact between oxygen and fuel.
(ii) In cylinders, CO2 is kept in the liquid form. When released, it expands enormously. This brings down the temperature of the fuel, which helps in controlling the fire.
9. It is difficult to burn a heap of green leaves but dry leaves catch fire easily. Explain.
Soln:
A heap of green leaves contains a lot of moisture in it, hence its ignition temperature is high. Therefore it does not catch fire easily.
But dry leaves have no moisture content in it, hence its ignition temperature is low. Therefore it catches fire easily.
10. Which zone of a flame does a goldsmith use for melting gold and silver and why?
Soln:
The goldsmith mainly uses non-luminous flame which is termed to be the outermost part of the flame. This part of the flame is used because the outermost flame undergoes complete combustion and is considered as the hottest part of the flame.
11. In an experiment, 4.5 kg of a fuel was completely burnt. The heat produced was measured to be 180,000 kJ. Calculate the calorific value of the fuel.
Soln:
12. Can the process of rusting be called combustion? Discuss.
Soln:
No, because rusting is an exothermic process as heat is liberated during rusting. On the other hand, combustion is a chemical process in which a substance reacts with oxygen to release energy in the form of heat or light.
13. Abida and Ramesh were doing an experiment in which water was to be heated in a beaker. Abida kept the beaker near the wick in the yellow part of the candle flame. Ramesh kept the beaker in the outermost part of the flame. Whose water will get heated in a shorter time?
Soln:
The water placed in the outermost part of the flame will be heated in a short time since it is non-luminous flame and is regarded as the hottest part of the flame. So Ramesh’s beaker will be heated first. However, Abida who placed the beaker in the luminous flame (yellow flame)is comparatively less hot.
List conditions under which combustion can take place?
The burning of a substance in the presence of oxygen is defined as combustion.
The conditions under which combustion can take place are
- The presence of air or oxygen.
- The presence of fuel plays a significant role.
- Ignition temperature is maintained (It is defined as the substance that catches fire at its lowest temperature.)
Explain how the use of CNG in automobiles has reduced pollution in our cities?
CNG played an important role in reducing pollution among automobiles for the following reasons
- CNG is comparatively a cleaner fuel.
- The CNG can be an alternative for diesel, petrol and propane/LPG.
- It usually contains a few undesirable gases than the other fuels mentioned above.
- The combustion of fuels like petroleum causes many unburnt carbon particles along with carbon monoxide which leads to respiratory diseases.
Comparison of LPG and wood as fuels?
Wood
- It is considered as a traditional fuel used for both domestic and industrial purposes.
- Wood produces a lot of smoke which pollutes the atmosphere and cause respiratory diseases.
- The usage of wood to a large extent causes deforestation.
- The calorific value of wood ranges between 17000 to 22000 kJ/kg
- However, wood may be used as a furnace, stove or fireplace in indoors while it is used for a campfire, furnace at outdoors.
LPG
- The usage LPG (Liquefied petroleum gas) has replaced wood.
- It doesn’t release smoke and other pollutants
- It is a cleaner fuel
- The fuel efficiency of LPG is more than that of wood.
- The calorific value of LPG is 55000 kJ/kg
- Hence LPG is mostly preferred choice
How the calorific value of a fuel is expressed?
Calorific value is defined as the energy contained in the fuel. It is expressed in the form kJ/kg
kJ-kilo joules
kg- kilogram
Which zone of a flame does a goldsmith use for melting gold and silver and why?
The goldsmith mainly uses non-luminous flame which is termed to be the outermost part of the flame. This part of the flame is used because the outermost flame undergoes complete combustion and is considered as the hottest part of the flame.
Can the process of rusting be called combustion? Discuss.
No, because rusting is an exothermic process as heat is liberated during rusting. On the other hand, combustion is a chemical process in which a substance reacts with oxygen to release energy in the form of heat or light.
No comments:
Post a Comment